Set Card Format; Alarm Setting; Components For Alarm - EverFocus EFC304 User Manual

Press any of the 1-8 numeric keys to change the format setting of each reader. Press
NOTE: LCD format will display more information, include current time, card serial number,
employee full name (if value is set), success or failure of current access verification. The screen of the
reader must be an LCD, shown as following:
If the screen of the reader is LCD, but set the format is LED, it is shown as following:

5.8.7 Set Card Format

At the following submenu:
Press to enter Card Format Setting. As shown below, the system will show what the reading card
direction of all readers is. The default setting of card format is N. Note: this feature only applies the
reader released after Q3, 2010.
Press any of the 1-8 numeric keys to change the format setting of each reader. Press
NOTE: Users do not need to take care of what is the detail of this reading direction. The user just
chooses the correct format when the card serial number shown on the LCD screen matching the
number printed on the card self.

5.9 Alarm Setting

NAV Controller is equipped with powerful alarm functions. With alarm modules and door modules fully
installed, the controller can accommodate up to 10 alarm inputs and 18 alarm outputs. In the meantime,
the controller also provides a very flexible configuration. Any event can be arbitrarily allocated to single
or multiple alarm outputs. Alarm components, configuration basics, and menu settings are introduced
below.

5.9.1 Components for Alarm

NAV Controller consists of two basic components: one main module and one door module. Users can
additionally install three more door modules and one alarm module.
2010-06-18 FRI 09:38
000005398787
Kelly
Verify Succeed!
OPEN
Set Card Format
CardFormat Setting
NNNNNNNN
46
NAV IP Access Controller
to exit.
to exit.