Arm/Disarm; Arm The Systemusing The Controller Keypad; Disarm The Systemusing The Controller Keypad - EverFocus EFC304 User Manual

Nav ip access controller
Hide thumbs Also See for EFC304:
Table of Contents

Advertisement

5.12 Arm/Disarm

After an alarm module is installed, it defines 10 arm zones for its 10 alarm inputs (including the 2 alarm
inputs on main module). NAV Controller can treat alarm inputs in 10 arm zones in a very flexible manner.
These 10 arm zones can be armed or disarmed on the controller as described below.

5.12.1 Arm the Systemusing the Controller Keypad

User must have the ARM PIN in order to utilize this function. Please refer to the section "Set ARM PIN" in
this chapter for instructions on how to set ARM PIN. After system installation, the date and time
information will be displayed on the LCD, as shown below:
When
on the keypad is pressed, the system prompts the user to enter a password, as shown
below:
After entering the password, press
password is verified, the current system ARM status will be displayed as shown below:
Press
to arm all active arm zones. The following message is displayed:
Press
to exit. The controller will wait for the period of time defined as "alarm delay" and then arm
all active arm zones.

5.12.2 Disarm the Systemusing the Controller Keypad

In order to utilize this function, the user must have the ARM PIN and the card must be logged in as ARM
enabled. Assuming the system is in armed status, the user swipes the card to access the door. The
controller will disarm all active arm zones in arm delay time. For example, if the system is in armed
status and a card is presented, the controller will disarm all active arm zones for the amount of time
assigned as the arm delay. During this time, no alarm outputs will be generated even if an alarm input is
triggered.
Similar to the procedure to arm the system, press
press
to confirm. After the password is verified the current system ARM status will be displayed as
shown below:
Press
to disarm all active arm zones. The following message is displayed:
2009-06-18
THU 09:38
Password
______
to confirm. The default password is 00000000. Once the
System Disarmed
[ENT] to Arm
System Armed
[ENT] to Disarm
on the keypad. Input the ARM password and
System Armed
[ENT] to Disarm
59
NAV IP Access Controller

Advertisement

Table of Contents
loading

This manual is also suitable for:

Efc302Efc308Efc306

Table of Contents