Table of Contents
Advertisement
Note: If the screw holes of the controller do not line up properly with the enclosure,
some filling may be required for adjustment.
1. Use the supplied mounting template to position the holes for the support frames and
then mount the two support frames on a wall.
Note: If using the metal enclosure, use the four pre-drilled holes on the back wall of
the enclosure and then mount the two support frames on the interior of the
enclosure.
2. Mount the controller base board to the support frames.
a.
Place the controller base board on the support frames. Line up the four latches
on the support frames with the holes on the controller base board. Once lined up,
slide the controller base board down to secure it in place.
b. Secure the controller base board to the support frames using the supplied two
screws.
Figure 2-2
Figure 2-3
14
NAV IP Access Controller
Advertisement
Table of Contents
