EverFocus EFC304 User Manual page 96

NAV IP Access Controller
All the properties of a card are shown as below. Check or uncheck the boxes to enable or
disable the functions.
Valid: Indicates whether the registered card is activated. Check this item to activate the
card. The other attributes of the card may not act until the card is activated. The card will
be invalid in case of not checking.
First Card: It indicates that the card held by the Cardholder is the first card and is used for
opening the door when setting normally opened function of the door region. If the
controller 0001 sets the door to be normally opened at a.m. 9:00-11:00, during this period
of time, the Cardholder holding the card with the first card attribute swipes the card on the
card reader under the controller to activate the normally opened state of the door in the
corresponding door region.
Arm/Disarm: Whether the cardholder has the right to arm/disarm the system on a keypad
reader. When an arm enabled card is presented to the reader, the system will be disarmed
for a time period so that the cardholder can enter/exit the arm zone without triggering an
alarm. This time period is defined by arm delay time in the system.
Check APB: Whether anti-passback (APB) is enabled for the card. If APB_EN is enabled for a
card, and the controller APB function is enabled, the APB setting is in effect for the card.
Refer to Anti-Passback (APB) setting for details
PIN Enabled: Cardholder can set up an 8-digit door password for NAV Controller. To
enable/disable, use functions in door setting, access authority setting or card schedule
setting.
Note: To use the password feature, the reader connected to the controller must
feature a keypad function.
Force Pin: The duress password is used for raising an alarm when the cardholder opens the
door under duress and is only valid when the door is set to open with a password. The
duress password has 2 digits. In case of using the duress password, first input the first 6
digits of the normal password and then input the duress password and confirm, then the
alarm is generated and the door is opened.
Check Expire: whether the card has an expiration date. If Card Expiration is checked, the
card can only be used within the expiration date. An expired card cannot gain access to the
system and an "expired card" event will be generated if an expired card is swiped on a
reader. The time set in the expiration date is the end of the expiration date. It can be
accurate to minute.
Private Schedule: refers to the verification mode for cardholders to enter/exit doors. Card
schedule setting is shared with access group schedule setting. To select a special card
schedule for a card, user needs to add a new schedule in "access group schedule setting"
and then apply the schedule for the card in "card schedule". If "card schedule" is enabled,
the system will follow the card schedule. In this situation, door verification control will not
be applied to this card.
88