Add A (Batch) Card - EverFocus EFC304 User Manual

14.1.1 Add a (Batch) Card

In the card setting page, click the "Add" button and a pop-up window appears
Steps:
1) In the window, input the card number, if users want to add more than one card
that its serial number is consecutive, please check the "Mass Cards" first, and then
input the batch number, the inputted serial number will be as the start number.
2) Set the card's properties including valid, first card, arm/disarm, APB, password
status and use the expiration etc. then input the password and force PIN , select
the access group, if using the card's schedule, please check the "Private Schedule"
first.
3) Assign one or more cards to one cardholder, after inputted the employee number,
the matched name will automatically pop-up, click to select it. Empathy the user
can also input employee name first.
4) Click the "Save" button, the card will be added to the list.
Note: To know the details about added, modified and deleted operations please
refer to 5.2.19.
Card number: Input the number, the software supports various kinds of card type. Each
type will be converted to according format. Use 10 decimal to be a sample, if its length is
shorter than 10, the software will add "0" at the beginning of the number.
ID card is Wiegand-26 format, which means 26 bits. Discarded the first 2 and last 2 parity
numbers, the remaining 24 digit will be converted to 10 decimal.
•
Users can read the number printing on the card.
•
Swipes the card on the reader, then user can find the card number in the access
denied record list on monitoring event page of the software.
Figure14-2Add a (batch) Card
120
NAV IP Access Controller