Table of Contents
Advertisement
12.1.5 Alarm Time
On the alarm time setting page, users can set the alarm duration time for the specified
controller. Click the "Alarm Input" tab, the setting page appears as below:
Steps:
1) Click the "Alarm Time" tab.
2) Select an alarm to be set in alarm list.
3) Input alarm time.
4) Click the "Save" button to save the change.
12.1.6 APB Area
On the APB Area page, users can configure the APB area, including: area name, enable or
not, open door when APB check fail or not. The APB function is a control function to
prevent the cardholder from repeatedly using the card for entry into the same area without
leaving. To perform anti-Pass-Back, two card readers for entrance/exit can be designed.
The cardholder must swipe the card on the entrance and exit card readers alternately.
Click the "APB Area" tab, the setting page appears as below:
Figure12-6Alarm Time
Figure12-7 APB Area
108
NAV IP Access Controller
Advertisement
Table of Contents
