Alarm Input - EverFocus EFC304 User Manual

Name: input a name for the reader.
Door location: indicates the location of the reader. Input a desired location name of the
reader (corresponding to the assigned door).
Input time: set up a max waiting time for inputting the password when the verification
needs to input a password. If more than the time, the controller display will go back to
main screen.
Outcome: indicates if the card reader is in door entry position or door exit position. If the
item is checked, it indicates that the card reader is in the door exit position.
Keypad: Indicates the reader features a keypad. For a keypad reader, if a card PIN is
enabled and the verification level is "card plus PIN", one must enter card PIN using the
keypad to gain access to the door.
System reader: indicates if the card reader is a system reader. A system reader can
transmit a card number to the controller to enroll cards to the controller. Any reader
connected to the controller can be set as a system reader.
Source area /Destination area: These settings are for APB function. Select the source area
(entry) and destination area (exit) from the drop-down list. To set up the APB area, please
efer to Anti-Passback (APB Area) page for details.
Steps:
1) Click the "Reader" tab.
2) Select the reader which needs to be set.
3) Input reader information including: reader name, door location, input time, keypad
reader, system reader, source area, destination area etc.
4) Click the "Save" button to save your changes.

12.1.3 Alarm Input

Click the "Alarm Input" tab, the setting page appears as below:
Name: input a name of the alarm input.
Fire Alarm: indicates whether this alarm input is a fire alarm or not.
Figure12-4Alarm Input
103
NAV IP Access Controller