Table of Contents
Advertisement
Press
and system will prompt the user to enter serial number, as shown below:
After entering the serial number, press
card has 6 properties that can be modified. Use
5.6.4.7
Status Setting
A card can be set as enabled or disabled at the following submenu:
Press
and system will show the status of current card as the figure below. Press
between the two statuses. Press
exiting.
5.6.4.8
First Card Setting
A card can be set as either first card or not from the below submenu:
Note: First card property indicates if the card can trigger the scheduled door verification rules. For
example, even when the doors are configured as always open during the office hour, but it will still
remain locked if NO card with enabled "First card" property yet presented and gained the access to the
doors in the office hour. For each day, the door verification schedule will be triggered (in this example,
become to unlocked in office hour) only after a card with enabled "first card" presented and gained the
access.
Press
and system will show the "First card" setting of the card as the figure below. Press
toggle between ON/OFF status of the first card setting.
5.6.4.9
Anti-Passback (APB) setting
NAV Controller features the Anti-Passback (APB) function on each card. If APB is enabled, cardholder
must pass the door in the alternating enter/exit. That is, if the card is swiped to access the door, then
Input Card Serial
card#:___________
to enter to the submenu for setting card properties. Each
Status Setting
to exit. The selected value is the one shown on window when
Card Disabled
[ENT] to Toggle
1st-person-in Setting
1st-person enabled
[ENT] to toggle
and
to choose desired properties.
Card Enabled
[ENT] to Toggle
1st-person disable
[ENT] to toggle
38
NAV IP Access Controller
to toggle
to
Advertisement
Table of Contents
