EverFocus EFC304 User Manual page 91

Click "OK" again and re-log in to the controller using the changed IP address.
Click the "Reset" button to read and display the network settings in the current controller
in the page input box.
Click the "Local Time" button and the time of the controller will synchronize with the local
time. The required time can also be set by the user. Click the "Set" button to save the time
settings.
Select the required time zone or the time zone where the location is located, click the "Set"
button to complete the controller time zone settings.
Enable sending event to xms server: Check the box to enable sending events from
controller to the XMS server.
Xms server address: Input the IP address of the XMS server.
Xms server port: Input the port number of the XMS server. The default port number is 80.
Xms server user: Input the user name of the XMS server.
Xms server password: Input the password of the XMS server.
Repeat xms server password: Input the password of the XMS server again.
ID Type: Before adding cards to the controller, select an ID type (card format) from the
drop-down list for this controller and then click the "Save" button. The card format
information will be displayed in the Example and below column fields which cannot be
modified.
Note: If you also adopt EverFocus' ENS2000 software for central management, you
can edit or add new card formats to the controller through ENS2000. For more details,
please refer to 4.3.1 Card Format in ENS2000 User's Manual.
Note: If your controllers have been connected to the ENS2000 software, once the
card format has been set up in the ENS2000 software, the connected controllers will be
automatically applied with the same card format.
Note: You can further configure the event settings for ENS2000 in the XMS server.
For more details, please refer to 4.3 Event in Genie XMS User's Manual.
83
NAV IP Access Controller