Hitachi TM3030 Plus Instruction Manual page 279

Code Error Message
1420 Something wrong in Disk.
Failed to save the image.
Start up the main unit and
application again.
Contact service if the failure
occurs repeatedly.
1421 Memory size is inadequate.
Failed to save the image.
1422 The same File Name has been
found.
Do you replace it by a new
file?
1423 Memory size is inadequate.
Change the destination of an
image to save.
1425 File Name is not valid.
Use a different File Name.
Countermeasure
Failed to access to the hard disk drive during
image data saving. Image could not be saved
normally.
Click the [OK] button to close the message.
Restart the system by the following procedure.
1. Turn off the PC power.
2. Turn off the main unit power.
3. Restart the PC.
4. Turn on the main unit power and start the
application.
If the same message appears repeatedly after
restart of the system, contact the nearest service
representative.
This message appears when free space of the
hard disk is not adequate for image data saving.
Image could not be saved normally. Click the
[OK] button to close the message. Secure
adequate free space in the hard disk.
A file with the same name already exists in the
destination folder to save. Click the [OK] button
to overwrite the file. Or click the [Cancel] button
to display the data saving window again.
During image data saving, it was detected that a
free space in the hard disk or data saving
medium is not adequate. Image data could not
be saved normally. Click the [OK] button to close
the message. Secure an adequate free space in
the hard disk or data saving medium. Saving
image data requires approximately 350 KB for
Quick Save, and approximately 1.3 MB for Save
(in the case of BMP format images).
The following characters such as ¥, /, :, ;, *, ?, ",
<, >, |, !, ', or & cannot be used for file names.
Click the [OK] button to display the data saving
window again. Save the image with a valid file
name.
5 - 42