Hitachi TM3030 Plus Instruction Manual page 179

1a. Specimen position monitor
The center of green cross line shows the home position of the motor drive stage. A
horizontal green line is X-axis, and a vertical green line is Y-axis. The blue frame
shows the movable range of the stage.
1b. Specimen stub image
Shows the reference image of the specimen stub. It moves according to the actual
movement of the stage.
1c. Current observation marker
The red marker shows an electron beam irradiation position.
1d. Specimen stub size
Click the button, and the pull-down list is displayed where the specimen stub size can
be selected. The value of the specimen stub size box shows the current size.
1e. Home position button
Moves the motor drive stage to the home position.
NOTE : In the following cases, the dialog message shown below is displayed until the
initialization processing is completed. At this time, the operation screen cannot be
operated.
 In the case where the application has been started but the stage initialization
(starting point movement) is not completed.
 When re-initialization of the stage is occurred.
2. Mouse Control Mode
Displays the triangular stage move buttons on the observation area. The following "8
Points", "4 Points", and "None" are selectable.
For the details, refer to 4.2.7.2 Searching for Field of View (Motor Drive Stage).
Figure 4.3.7-3 Stage Initialization
4 - 60