Table of Contents
Advertisement
Chapter Four Setup of SATA RAID
This chapter mainly introduces the configuration of onboard Intel SATA controller
HostRaid and its application method. If the server you purchased does not use onboard
SATA HostRaid, you can skip this chapter.
If it does use onboard SATA HostRaid, please enter BIOS and set Advanced→SATA
Configuration→SATA Mode option to [RAID Mode] and it only supports Windows
system at this point.
4.1 How to Enter the Configuration Interface of SATA
1. During boot, the screen will display:
Press [CTRL-I] to enter Configuration Utility...
2. At this time, press [Ctrl][I] to enter SATA Host RAID configuration interface.
4.2 Control Key Application
Key
<↑><↓>
For moving cursor and modifying menu option value in different
menus
TAB
For selecting the next menu configuration items
Enter
For selecting menu
Esc
For exiting menu or back to the previous menu from submenu
4.3 SATA HostRAID Setup
After entering the SATA HostRAID configuration interface, these information will
pop out, including the menu list information, the information of the HDDs connected
to the SATA controller (HDD ID number, HDD model, HDD capacity and whether the
HDD is part of the volume, etc), and the existing RAID volume information (including
volume ID number, name, RAID level, capacity, state and whether can boot, etc.), as
shown in the below figure:
Description
25
Hide quick links:
Advertisement
Table of Contents
