Inspur NP5540M3 Manual page 22

Chapter Three System Setup
interfaces, and enables the user to set SATA controller model and all SATA interfaces.
* SATA Mode
This item is used to set onboard SATA controller modes including [Disabled], [IDE
Mode], [AHCI Mode] and [RAID Mode] four items.
If you want to use serial devices as parallel IDE storage devices when onboard
SATA controller is used, please set this item to [IDE Mode].
If you do not use RAID and want to connect 1-6 SATA devices when onboard
SATA controller is used, please set this item to [AHCI Mode].
If you want to use Intel SATA HostRAID when onboard SATA controller is used,
please set this item to [RAID Mode] (only Windows system is supported at this time).
* Serial-ATA Controller 0
This item only appears when SATA Mode option is set to [IDE Mode]. When set
to <Enhanced>, it can support 4 SATA 3.0Gb/s devices.
* Serial-ATA Controller 1
This item only appears when SATA Mode option is set to [IDE Mode]. When set
to [Enhanced], it can support 2 SATA 3.0Gb/s devices.
● USB Configuration
This menu is used to set some configuration related to USB and displays the USB
devices automatically detected by the system.
* Legacy USB Support
The traditional USB devices support function setup and there are three options
<Enabled>, <Disabled> and <Auto>. If set it to [Auto], the default does not support
traditional USB devices when USB devices are not connected.
● Onboard LAN Configuration
* Launch PXE Oprom
This item is used to open or close the PXE function of onboard network card, in-
cluding [Disable] and [Enable] (default configuration) two items.
When this item is set to <Enabled>, correspondingly, the user has to select to use
network card of PXE function.
3. Chipset Menu
● CPU Advanced Settings
This menu is used for the setup of QPI related information and memory related
items.
* QPI Configuration
16