Inspur NP5540M3 Manual page 45

If it is onboard AHCI configuration, please press key <F6>.
Notes: when installing EMT64bit version system, if it prompts the server type
purchased, you can select configuration according to the detailed configuration of
purchased server.
For onboard Intel SATA AHCI configuration, when the system displays "Setup
could not determine the type of one or more mass storage...", press 'S' key.
If USB floppy drive is used (please connect USB floppy drive well before the
system starts up.)
When the system prompts to insert a floppy disk, insert the corresponding driver
floppy disk and press [Enter] key.
⊙ If onboard SATA controller AHCI configuration is used, follow the above
operations described above and insert the corresponding program floppy disk "AHCI
driver_EM64T for Windows 2003". Select "Intel(R) C600 Series Chipset SATA AHCI
Controller" from the drive list and press [Enter] to load driver.
If Inspur driver U disk is used (please connect Inspur driver U disk well be-
fore the system starts up.)
Firstly, ensure that the corresponding driver has been made into the [3.5 Floppy
disk (A:)] partition of the Inspur driver U disk.
⊙ If onboard SATA controller AHCI configuration is used, select "Intel(R) C600
Series Chipset SATA AHCI Controller" from the driver list and then press [Enter] to
load driver.
4. The system displays:
Welcome to Setup.
This portion of the Setup program prepares Microsoft(R) Windows(R) to run on
your computer.
⊙ To set up Windows now, press ENTER.
⊙ To repair a Windows installation using Recovery Console, press R.
⊙ To quit Setup without installing Windows, press F3.
Here, we default it is the first installation, so press <Enter> key to continue the
installation.
5. The system displays Windows Licensing Agreement. The user can read the li-
censing agreement by pressing <Page Down> key. And after finishing reading or not to
read the agreement, you can directly press <F8> key to accept the agreement.
6. The system displays
Chapter Six Install Operating System
39