Inspur NP5540M3 Manual page 32

Chapter Four Setup of SATA RAID
The executable menus of the configuration interface of SATA HostRAID are the
following four:
● Create RAID Volume
Create RAID volume.
● Delete RAID Volume
Delete existing RAID volume.
● Reset Disks to Non-RAID
Reset HDDs in volume to non-RAID state.
● Exit
Exit the configuration interface of SATA HostRAID.
Ⅰ . Create RAID Volume menu
After entering the configuration interface of SATA HostRAID, it can select the
menu with up and down arrow keys, and then press [Enter] key to create RAID volume
menu.
The system will display the following menu options:
Name: Please input the volume name of less than 16 characters without special
characters.
RAID Level: Please select RAID volume level. If it has not created volume at
present, there are four volumes for selection, such as RAID0 (Stripe), RAID1(Mirror),
RAID10 (RAID0+1) and RAID5 (Parity), and please select the levels based on the ac-
tual demand.
RAID0: it allows 2 or more than 2 hard disks to form this RAID volume.
RAID1: it allows 2 hard disks to form this RAID volume.
RAID10: it allows 4 hard disks to form this RAID volume with 4 or more hard
26