Inspur NP5540M3 Manual page 38

Chapter Five SAS RAID Setup
you sure you want to delete "Volume*"? (Y/N):". If confirming to delete RAID vol-
ume, please enter "Y". And if you want to cancel the operation of deleting RAID vol-
ume, please enter "N".
III. Reset Disks to Non-RAID menu
After entering the configuration interface of SAS HostRAID, you can select the
menu by up and down arrows, and then press [Enter] key to enter the menu or input di-
rectly.
The system will display all hard disks in RAID volume. Please select hard disks
to be reset by [Space] key based on actual demand, and then reset hard disk by pressing
[Enter] key. The system will again warn whether there is a need to reset the hard disk,
and enter Y or N according to the prompts.
Note: when resetting the hard disks, all data on hard disk will be lost, and at the
same time the hard disk will not again belong to RAID volume.
IV. Exit menu
After entering the configuration interface of SAS RAID, you can select the menu
by the up and down arrows, and then press [Enter key] to enter the menu.
System prompts: "Are you sure you want to exit? (Y/N):". Enter "Y", and then
it will exit the configuration interface of SAS RAID. If entering "N", it will cancel the
operation and exit.
32