Chapter Three Setup Of Sas Raid; How To Enter The Configuration Interface Of Sata Hostraid; Control Key Application - Inspur Yingxin User Manual

controller 2
CLRTC1 CMOS clearing jumper
Enable/disable onboard display
VGA_SW1
controller
Notes:
1. When clearing the CMOS, the system must be off and the power should be disconnect
ed. After short-cutting the CLRTC1 jumper's Pin2-3, it needs to keep 5 seconds and then
use jumper cap to short-cut the Pin1 and Pin2 of CLRTC1 jumper (default configuration
state), and restore to the original state.
2. After the jumper operation, please install the side panel of the chassis.
Chapter Three SATA RAID Setup
This chapter mainly introduces the configuration of onboard Intel SATA controller HostRaid
and its application method. If the server you purchased does not use onboard SATA HostRaid, you
can not refer to this chapter.
If it does use onboard SATA HostRaid, please enter BIOS and set Advanced→SATA
Configuration→SATA Mode option to [RAID Mode], it only supports Windows system at this
point.

3.1 How to Enter the Configuration Interface of SATA HostRaid

1. During boot, the screen will display:
Press [CTRL-I] to enter Configuration Utility...
2. Press [Ctrl][I] to enter SATA HostRaid configuration interface.

3.2 Control Key Application

Key
↑↓
TAB
Enter
For moving cursor and modifying menu option value in
different menus
For selecting the next menu configuration items
For selecting menu
display controller (default).
Short-cutting pin2 and 3 to disable onboard
display controller
Short-cutting pin1 and 2 is normal state
(default).
Short-cutting pin2 and 3 is CMOS clearing
state
Short-cutting pin1 and 2 to enable onboard
display controller (default).
Short-cutting pin2 and 3 to disable onboard
display controller
Description