Chapter Four Sas Raid Of Swr Model Setup; How To Enter Sas Raid Conﬁ Guration Interface - Inspur Yingxin User Manual

Hide thumbs Also See for Yingxin:

Table of Contents

Chapter Four SAS RAID of SWR Model Setup

This chapter mainly introduces the SWR model conﬁ guration and utility of on-

board LSI SAS 1068E controller. You need to do a RAID0 array if using this controller

to connect single SAS hard disk.

Onboard SAS controller of SWR Model is defaulted to support RAID0 and

RAID10. The user needs to purchase I-Button for the system to support RAID5.

If SAS controller of the server you purchased is not integrated on the mother-

board, you can skip this chapter.

4.1 How to Enter SAS RAID Conﬁ guration Interface

When "Press Ctrl-M or Enter to run LSI Software RAID Setup Utility" appears

on the screen in system booting process, press <Ctrl>and <M> or press [Enter]. The

system will enter the RAID conﬁ guration interface.

4.2 SAS RAID Menu Description

When entering RAID conﬁ guration main interface, following main menus will be

available, as shown in the picture below22:

The following are respective explanation of each menu:

1. Conﬁ guration Menu

Select Conﬁ guration and press [Enter] to enter the interface as shown in the pic-

ture below:

Table of Contents