Chapter Four Sas Raid Of Swr Model Setup Chapter Four Sas Raid Of Swr Model Setup; How To Enter Sas Raid Setting Interface; Sas Raid Menu Description - Inspur NF5220 Manual

Chapter Four Set Up SAS RAID of SWR Model Chapter Four Set Up SAS RAID of SWR Model
This chapter mainly introduces the SWR model confi guration and utility of on-
board LSI SAS 1068E controller. You need to do a RAID0 array if using this controller
to connect single SAS hard disk.
The SWR model of onboard SAS controller supports default of RAID0, RAID1,
RAID10. If you want to support RAID5, you need to purchase I-Button.
In case that the motherboard of the server you purchased does not integrate SAS
controller, you can skip this chapter.

4.1 How to Enter SAS RAID Setting Interface

4.1 How to Enter SAS RAID Setting Interface
1. The screen will display the following English prompt during the booting pro-
cess of the system: "Press Ctrl-M or Enter to run LSI Software RAID Setup Utility", at
the same time, press <Ctrl> <M> keys or [Enter] to enter RAID setting interface.

4.2 SAS RAID Menu Description

4.2 SAS RAID Menu Description
When entering RAID confi guration main interface, following main menus will be
available, as is shown in the picture below:
The following are respective explanation of each menu:
1. Confi gure menu 1. Confi gure menu
Select Confi gure and press [Enter] to the interface, as is shown in the picture be-
low:
Chapter Four SAS RAID of SWR Model Setup Chapter Four SAS RAID of SWR Model Setup
19