Chapter Four Sas Raid Setup; How To Enter The Confi Guration Interface Of Sas; Control Key Application; Sas Raid Setup - Inspur Yingxin Manual

Hide thumbs Also See for Yingxin:

Table of Contents

Chapter Four SAS RAID Setup

This chapter mainly introduces the configuration of onboard SAS controller

RAID and its application method. If the server you purchased does not use onboard

SAS RAID, you can not refer to this chapter.

If you use onboard SAS RAID, you need to enter BIO, set the Chipset→PCH→SCU

devices item to [Enabled], and then set Onboard SAS Oprom item to [Enabled].

4.1 How to Enter the Conﬁ guration Interface of SAS RAID

1. During boot, the screen will display:

Press [CTRL-I] to enter Conﬁ guration Utility...

2. Press [Ctrl][I] to enter SAS RAID conﬁ guration interface.

Key

For moving cursor and modifying menu option value in differ-

↑↓ ↑↓

ent menus

TAB

For selecting the next menu conﬁ guration items

Enter

For selecting menu

Esc

For exiting menu or back to the previous menu from submenu

After entering the SAS RAID conﬁ guration interface, these information will pop

out, including the menu list information, the information of the HDDs connected to the

SAS controller (HDD ID number, HDD model, HDD capacity and whether the HDD

is part of the volume, etc), the existing RAID volume information (including volume

ID number, name, RAID level, capacity, state and whether can boot information), as

show in the below ﬁ gure:

Chapter Four SAS RAID Setup

Description

Table of Contents