Inspur NP5540M3 Manual page 13

SATA Controller
Management Card
Management Card Chip
Management Card Inter-
face
Network Card
Network Card Controller
PCI Expansion Slot
PCI Bus Type
PCI Slot
Hard Disk
Hard Disk Type
Hard Disk Number
External Storage Drive
Optical drive (Optional)
Inspur driver U disk
Power Supply
Specification
Power Input
Physical Specifications
External size of Package
Chapter Two Product Introduction
South bridge integrates SATA controller. The mother-
board has 4 SATA II interfaces and 2 SATA III interfac-
es. When standard optical drive is configured, 1 SATA
interface is used to connect SATA optical drive.
Onboard Aspeed 2300 chip, IPMI2.0+IKVM supported
Special IPMI management interface can be used, or re-
use the first network card of Intel 82574
Onboard Intel 82574 dual-gigabit network card;
PCI/PCI-Express bus, supports vertically inserted full-
height expansion card
3 * PCIE 2.0 x8 slots, support 3 with dual CPU; sup-
port 2 with single CPU
2 * PCIE 2.0 x4 slots, support 2 with dual CPU; sup-
port 1 with single CPU
1 * PCI slot
3.5" SATA hard disks, 2.5" SATA and SAS hard disks;
different models support different disk types, please re-
fer to the actual configuration.
Support up to 4 pieces of built-in 3.5"SATA hard disks
Support up to 16 pieces of hot-swap 2.5"SATA/SAS
hard disks
Optional SATA optical drive
Optional Inspur driver U disk used to load hard disk
controller driver when installing the operating system
manually
500W single power supply or above 1+1 redundant
power supply
Please refer to the specification on the nameplate of
host machine.
W (width) 601mm; H (height) 472mm; D (depth)
733mm
7