Ipv6 Neighbor Settings - D-Link DGS-3200 Series User Manual

IPv6 Neighbor Settings

To configure the Switch's IPv6 neighbor settings:
Open the Configuration folder and click IPv6 Neighbor Settings. The web manager will display the Switch's current IPv6
neighbor settings in the table at the bottom of this window, as displayed below.
Enter the Interface Name, Neighbor IPv6 Address, and the Link Layer MAC Address and then click the Add button. The State
can be set to All, Address, Static, or Dynamic.
To look for an IPv6 Neighbor Settings table entry, enter the Interface Name, select the desired State in the middle section of this
window, and then click the Find button.
To delete all the entries being displayed on the table at the bottom of this window, click the Clear button.
The following parameters may be configured or viewed:
Parameter Description
Interface Name Enter the name of the IPv6 neighbor. To search for all the current interfaces on the Switch, go to
the second Interface Name field in the middle part of the window, tick the All check box, and then
click the Find button.
Neighbor IPv6 Enter the neighbor IPv6 address.
Address
Link Layer MAC Enter the link layer MAC address.
Address
State Use the drop-down menu to select All, Address, Static, or Dynamic.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 8. IPv6 Neighbor Settings window
33