Creating A User Account - D-Link DGS-1510 Series Hardware Installation Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address
H/W Version
Please Wait, Loading V1.00.010 Runtime Image ..............
UART init .................................................
Starting runtime image
Device Discovery ..........................................
Configuration init ........................................
Switch con0 is now available
Press any key to login...
During the boot-up procedure, we can find the PROM version, MAC address, Hardware Version, and
Firmware Version used by this Switch.
By default, there is no login username or password configured on this Switch. The CLI prompt will
immediately be available, as shown below.
Switch>
Now the switch can be configured.
CAUTION: For security reasons, it is highly recommended to configure a personal
username and password for this Switch.

Creating a User Account

This section will discuss how to create a login username and password on this Switch. This login details
will be applied not only for access to the CLI, but also for access to the Web UI, Telnet, SSH, and SSL
interfaces. The same username and password will be used for these connections.
: 00-01-02-03-04-00
: A1
DGS-1510-28P Gigabit Ethernet SmartPro Switch
Command Line Interface
Firmware: Build 1.00.010
Copyright(C) 2014 D-Link Corporation. All rights reserved.
28
V1.00.004
100 %
100 %
100 %
100 %
100 %