Usp - Frame Relay Interface - Avaya Media Gateway G350 User Manual

The following table lists the configuration fields in the PPP tab of the USP Configuration dialog
box and their descriptions:
Table 47: USP Configuration - PPP Parameters
Field
Peer Address
MTU
Keepalive
Operational Status
IPCP Status
Backup Interface

USP - Frame Relay Interface

For USPs configured with a frame relay interface, the USP dialog box contains five tabs:
Serial Port
●
tab of the USP - Frame Relay dialog box, refer to
Advanced
●
the fields in the Advanced tab of the USP - Frame Relay dialog box, refer to
page 129.
Frame Relay
●
Description
The IP address of the PPP session's peer.
Maximal Transmission Unit. The size of the largest packet that can be
transmitted over this PPP session.
The number of seconds between keepalive messages. If this is 0,
keepalive messages are not sent.
The operational status of the interface. Possible statuses include:
Up - The interface is up and can transmit and receive packets.
●
Down - The interface is down due to some failure, and cannot
●
transmit or receive packets.
Testing - The interface is in testing mode and cannot transmit
●
or receive regular data.
Standby - The interface is a backup interface and cannot
●
transmit or receive packets unless the primary interface it
backs up fails.
Disabled - The interface is disabled. It cannot transmit or
●
receive packets.
Partially Down - The interface is up. However, some interfaces
●
(or PVCs) layered on top of this interface are Down. Some
packets can be transmitted and received.
IP Control Protocol. The state of IPCP for this PPP session. Possible
statuses include:
Open - IP packets can be transmitted and received over the
●
PPP session.
Not-Opened - IP Packets cannot be transmitted and received
●
over the PPP session.
The interface configured to back up this interface.
- Basic information abut the USP. For information on the fields in the Serial Port
- Information about the channels that comprise the interface. For information on
- Information about the frame relay configuration on the USP.
"Serial Port" on page
Issue 5 October 2007
USP Configuration
127.
"Advanced" on
133