Avaya Media Gateway G350 User Manual page 205

Table 66: Device Trap Managers Table (continued)
Item
Enable SNMP
Authentication-Failure
trap
Enable RTP QoS trap
Enable RTP QoS Fault trap When checked, enables RTP QoS Fault trap.
Manager IP
User Name
Notify Type
Notify Mode
Inform Timeout
Inform Retry Count
Config Change Events
SW Redundancy Event
PoE Events
Hardware events
RMON Events
DHCP Client Events
FileSys Events
DHCP Server Events
TFTP Events
WAN Events
Media Gateway Events
Security Events
Description
When checked, enables SNMP Authentication-Failure trap.
When checked, enables RTP QoS trap.
IP address of the management station that receives traps.
The SNMPv3 user authentication name.
The type of notification. Possible values are:
Trap
●
Event
●
Select the notification Mode. Possible values are:
SNMPv1
●
SNMPv3
●
The number of seconds for an event message to connect to the
manager before failing.
The number of failed event attempts before an event is
discarded.
When checked, configuration change events are sent to the
manager.
When checked, software redundancy events are sent to the
manager.
When checked, PoE events are sent to the manager.
When checked, hardware events are sent to the manager.
When checked, RMON events are sent to the manager.
When checked, DHCP client events are sent to the manager.
When checked, Avaya Load MIB events such as download and
upload success/failure/start, are sent to the manager.
When checked, DHCP server events are sent to the manager.
When checked, TFTP events are sent to the manager.
When checked, WAN events are sent to the manager.
When checked, Media Gateway events are sent to the
manager.
When checked, security events are sent to the manager,
including 802.1x and MSS notifications.
Configuring Trap Managers
Issue 5 October 2007
2 of 3
205