Viewing The Routing Table - Avaya Media Gateway G350 User Manual

The following parameters are displayed:
Table 72: Dynamic IP Interfaces Table Parameters
Field
IP Interface Name
IP Address
IP NetMask
Layer 2 Interface
name
Type
Oper Status
Redirects

Viewing the Routing Table

To display and update the Routing Table:
Select IP Route > Routing Table. The Routing Table window opens.
Static routes are displayed as read-only in the Routing Table. To configure or create static
routes, refer to
Description
The name assigned to the selected IP interface.
The IP address of this interface. This address is received from a
remote peer during the PPP-IPCP session, or from a DHCP server
using a DHCP client.
The IP network mask of the attached net/subnet.
The name of the Layer 2 interface with which this subnet is
associated.
The type of IP address assignment on the interface. Possible values
are:
DHCP - a dynamic IP interface created by activating the DHCP
●
client on the interface and getting an IP address from the DHCP
server.
Negotiated - a dynamic IP interface created by activating
●
PPP-IPCP on the interface and getting an IP address.
The operational status of the IP interface.
The status of ICMP Redirect service on the interface. Possible values
are:
Enable - Redirect messages are sent if the router is forced to
●
resend a packet through the same interface from which it was
received.
Disable - Redirect messages are not sent.
●
"Viewing the Static Routing Table" on page
Viewing the Routing Table
226.
Issue 5 October 2007 223