Avaya Media Gateway G350 User Manual page 51

Table 13: Port Configuration Dialog Box - General Tab (continued)
Field
Auto Negotiation
Status
Duplex Mode
Speed Mode
Flow Control Mode
Operational Status
Fault Messages
For more information on the user interface, refer to
page 32.
Description
The operational state of the Auto-Negotiation protocol between two
stations. Possible statuses are:
Pass - the Auto-Negotiation protocol is enabled and a
●
common protocol has been established.
In Progress - the Auto-Negotiation protocol is in the process
●
of detecting the communication capabilities of the endstations
and setting them to the highest common denominator.
Fail - the Auto-Negotiation protocol was not able to detect the
●
communication capabilities of the end station, or was unable
to set them to the highest common denominator.
Disabled - The Auto-Negotiation protocol is disabled.
●
The state of communication of the selected port. Possible values
are:
Full Duplex - the port can send and receive simultaneously.
●
Half Duplex - the port can either receive or send, but cannot
●
do both simultaneously.
The rate of communication of the selected port. Possible values are:
Ethernet
●
Fast Ethernet
●
Gigabit Ethernet
●
The state of flow control on the selected port.
The warning level of the selected port. Possible values are:
OK
●
Warning
●
Fatal
●
A list of fault messages.
Viewing Port Configuration
"Using Dialog Boxes and Tables" on
Issue 5 October 2007
3 of 3
51