Avaya Media Gateway G350 User Manual page 227

Table 74: Static Routing Table Parameters (continued)
Field
Next Hop
Layer 2 Interface
Name
Redistribute
Cost
Permanent
Static Preference
Route Type
Active
Description
The address of the next router of this route, via which the destination of
this route is reached.
Note:
If the static route is over the WAN Fast Ethernet
Note:
interface configured as a DHCP client, then this field
displays IP address (DHCP) if the DHCP client has a
default route; otherwise, it displays Unassigned
(DHCP).
Note:
You must specify Route Type before configuring Next
Note:
Hop.
The logical name of the local interface through which the next hop of
this route is reached.
Note:
You must specify Route Type before configuring
Note:
Layer 2 Interface Name.
If checked, static entries are advertised by RIP and OSPF. If
unchecked, static entries are not advertised.
Number of hops to the destination network, or the cost of the route for
OSPF routes.
The permanence status of the route. Possible statuses are:
Checked - The route is not disabled when a link on the route is
●
down.
Unchecked - The route is disabled when a link on the route is
●
down.
The preference of this route. Possible values are:
Low - Dynamic routes are preferred on this static route.
●
High - This static route is preferred on dynamic routes.
●
The type of static route. Possible values are:
Via - via the interface static route.
●
Discard - using a route which discards traffic.
●
DHCP - using the DHCP client next hop.
●
Regular - the regular static route.
●
The status of the route. Possible values are:
Yes - the route is active and affects traffic.
●
No - the route is not active and does not affect traffic.
●
Viewing the Static Routing Table
Issue 5 October 2007
2 of 2
227