Avaya Media Gateway G350 User Manual page 225

Table 73: Routing Table Parameters (continued)
Field
Protocol
Redistribute
Cost
Permanent
Static Preference
Route Type
Route Age
You can create, modify, or delete Routing Table static entries. For more information on editing
tables, refer to "Editing Tables" on page
You can limit the table entries displayed.
Description
The protocol through which the route was learned. The following
protocols can be specified:
Static - The route was manually configured to this device.
●
Local - The route represents a directly attached net/subnet and
●
corresponds to one of the IP interfaces configured to this
device.
RIP - The entry was learned from the RIP protocol.
●
OSPF - The entry was learned from the OSPF protocol.
●
If checked, static entries are advertised by RIP and OSPF. If
unchecked, static entries are not advertised.
Number of hops to the destination network, or the cost of the route for
OSPF routes.
The permanence status of the route. Possible statuses are:
Checked - The route is not disabled when a link on the route is
●
down.
Unchecked - The route is disabled when a link on the route is
●
down.
The preference of this route. Possible values are:
Low - Dynamic routes are preferred on this static route.
●
High - This static route is preferred on dynamic routes.
●
The type of route.
The number of seconds since this route was last updated or
otherwise determined to be correct.
210.
Viewing the Routing Table
2 of 2
Issue 5 October 2007 225