Table of Contents
Advertisement
Interface Control
Use the following procedure to set or change the interface control value.
1. When you select INT... from the Admin Procedures Screen, the following text displays with a
prompt to use the Right and Left navigation arrows to select a setting:
Ethernet:
PC Ethernet:
The values shown are the text strings associated with the current PHY1STAT on the
Ethernet line and the current PHY2STAT system value on the PC Ethernet line.
The PHY1STAT text strings are:
"Auto" when PHY1STAT = 1
●
"10Mbps half" when PHY1STAT = 2
●
"10Mbps full" when PHY1STAT = 3
●
"100Mbps half" when PHY1STAT = 4
●
"100Mbps full" when PHY1STAT = 5
●
"1000 Mbps full" when PHY1STAT = 6
●
Note:
A PHY1STAT value of 6 applies only to telephone models that support Gigabit
Note:
Ethernet (GigE), otherwise this value/choice does not display.
The PHY2STAT text strings are:
"Disabled" when PHY2STAT = 0
●
"Auto" when PHY2STAT = 1
●
"10Mbps half" when PHY2STAT = 2
●
"10Mbps full" when PHY2STAT = 3
●
"100Mbps half" when PHY2STAT = 4
●
"100Mbps full" when PHY2STAT = 5
●
"1000Mbps full" when PHY2STAT = 6
●
Note:
A PHY2STAT value of 6 applies only to telephone models that support Gigabit
Note:
Ethernet (GigE), otherwise this value/choice does not display.
Choice Selector
Choice Selector
Issue 2 December 2007
Interface Control
37
Advertisement
Table of Contents
