Table 31: E1/T1 Port Configuration Parameters (continued)
Field
(T1
Cablelength
only)
(T1 only)
Gain
Clock Source
(T1 only)
FDL
Local Loopback
Remote
Loopback
(T1 only)
Loopback
Status
Fault Messages
Description
The recommended maximum cable length.
The gain on this interface. Gain represents the level of signal boost
required to transmit across the circuit at the maximum cable length.
The source of the Transmit Clock. Possible sources include:
Line - The recovered receive clock is used as the transmit clock.
●
Internal - The local clock is used as the transmit clock.
●
The type of FDL used on this interface. Possible types include:
ANSI
●
AT&T
●
Both - ANSI and AT&T FDL are both used on this interface.
●
None - FDL is not used on this circuit.
●
A request to use a local loopback. A local loopback can be performed
using:
No Loopback
●
Payload Loopback
●
Line Loopback
●
Diag Loopback
●
A request to use a remote loopback. A remote loopback can be performed
using:
No Remote Loopback
●
Remote Line
●
Reset Remote Loopback
●
The type of loopback currently used by the port. Possible values are:
No Loopback
●
Near End Payload
●
Near End Line
●
Near End Inward
●
Far End Payload
●
Far End Line
●
Any faults that occurred on the port.
E1/T1 Port Configuration
2 of 2
Issue 5 October 2007
89