Siemens Hicom Office PhoneMail Installation And System Administrator's Manual page 19

Each Siemens switch discussed in this section is capable of providing user access to interstate
providers of operator services through the use of equal access codes. Modifications by aggre-
gators to alter these capabilities is a violation of the Telephone Operator Consumer Services
Improvement Act of 1990 and Part 68 of the FCC Rules.
Electrical Safety Advisory
While each Siemens switch discussed in this section is fully compliant with FCC Rules and
Regulations, it is recommended that an alternating current (ac) surge arrestor of the form and
capability suitable for the model of the system purchased be installed in the ac outlet to which
the system is connected. Consult with your Siemens representative or distributor to determine
the surge protector requirements for your system.
Facility Interface Information for the Hicom 150 E CS, OfficePoint and OfficeCom only
The following tables list facility interfaces, manufacturer's network interface port designations,
RENs or service codes, and network jacks.
This table lists the network trunk interfaces for loop-start and ground-start services.
Facility Interface
02LS2
02GS2
This table lists the station interfaces for analog private line (PL) services.
Analog PL Facility
Interface
OL13B
OL13B
This table lists the network digital trunk interfaces for digital services.
Digital Facility In-
terface
02IS5
G281-0507-00, April 15, 1998
Hicom Office PhoneMail, Version 1, Installation and System Administration Guide
Manufacturer's Network Interface
Port Designation
TMGL4
TMGL4
Manufacturer's Network Interface Port
Designation
8SLA (OPS)
4SLA (OPS)
Manufacturer's Network Interface Port
Designation
TMQ4 board
Important Notices
FCC and Industry Canada Compliance
REN
0.4B
0.4B
Service
Code
9.0 F
9.0 F
Service
Code
6.0 Y
lleg_sa.c01
Network
Jacks
RJ21X
RJ21X
Network Jacks
RJ21X
RJ2GX
Network
Jacks
RJ49
1-7