Siemens Hicom Office PhoneMail Installation And System Administrator's Manual page 16

lleg_sa.c01
Important Notices
FCC and Industry Canada Compliance
1.2.1.1 FCC Rules, Part 15
Each Siemens switch discussed in this section, except the Hicom 150 E CS OfficePoint, has
been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference,
in which case the user will be required to correct the interference at his own expense.
The Hicom 150 E CS OfficePoint has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a resi-
dential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
1.2.1.2 FCC Rules, Part 68
Each Siemens switch discussed in this section complies with FCC Rules, Part 68. A label on
the outside back of the cabinet identifies the FCC registration number, the ringer equivalence
number (REN), and other information. If requested, this information must be given to the tele-
phone company.
Disruption of the Network and T1
For networked systems using 1.544 Megabits per second (Mbps) T1 service, notify the tele-
phone company when the equipment is disconnected from the network. If any Siemens switch
discussed in this section disrupts the telephone network, the telephone company can discon-
tinue your service temporarily. If possible, the telephone company will notify you in advance. If
advance notice is not practical, they will notify you as soon as possible. You also will be in-
formed of your right to file a complaint with the FCC.
1-4
Hicom Office PhoneMail, Version 1, Installation and System Administration Guide
,
G281-0507-00 April 15, 1998