Resetting A System Parameter To Its Default Value - Siemens Hicom Office PhoneMail Installation And System Administrator's Manual

Country
Belgium
Philippines
Australia
India
Table 8-1 Tone Plan Table (Sheet 2 of 2)
To change the Call Progress Tone Plan:
1. Log into your mailbox and access the system administration menu.
2. Access the Maintenance Options menu by pressing
you for the Maintenance Password. Enter the Maintenance Password,
(Maintain).
4 6
3. Enter the parameter number to change. Enter
4. Office PhoneMail will play the current value of the Tone Plan ID number.
5. To change the Tone Plan ID number, enter a new value from the table above. Enter all
values as 2-digit numbers.
6. To accept the new Tone Plan ID number, press
PhoneMail will automatically end the administration session by hanging up. Upon
hang-up, Office PhoneMail will restart, and automatically install the new tone plan.
8.9

Resetting a System Parameter to its Default Value

At any time, you can reset a changed system parameter to its initial default value.
To reset a specific system parameter:
1. Log into your mailbox and access the system administration menu.
2. Elect to perform Maintenance Administration procedures by pressing
Office PhoneMail will not prompt you with this menu choice.
3. At the system prompt, enter the maintenance password:
(MAINTAIN).
G281-0507-00, April 15, 1998
Hicom Office PhoneMail, Version 1, Installation and System Administration Guide
Resetting a System Parameter to its Default Value
Tone Plan ID
34
35
36
37
Changing System Settings
. Office PhoneMail will prompt
8
.
2 0
. If you accept this value, the Office
6 2 4 6 8 2 4 6
lleg_sa.c08
6 2 4 6 8 2
.
8
8-7