Timer Quiet (Hwtacacs Scheme View); Timer Realtime-Accounting (Hwtacacs Scheme View) - HP 3600 v2 Series Command Reference Manual

no response in the specified period of time, the NAS buffers and resends the packet until it receives a
response or the number of transmission attempts reaches the configured limit. In the latter case, the NAS
discards the packet.
Related commands: reset stop-accounting-buffer and display stop-accounting-buffer.
Examples
# In HWTACACS scheme hwt1, enable the switch to buffer the stop-accounting requests getting no
responses.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] stop-accounting-buffer enable

timer quiet (HWTACACS scheme view)

Syntax
timer quiet minutes
undo timer quiet
View
HWTACACS scheme view
Default level
2: System level
Parameters
minutes: Primary server quiet period, in minutes. It ranges from 1 to 255.
Description
Use the timer quiet command to set the quiet timer for the primary server. When the primary server is
found unreachable, the switch changes the status of the server from active to blocked and keeps the
server in blocked state until this timer expires.
Use the undo timer quiet command to restore the default.
By default, the primary server quiet period is 5 minutes.
Related commands: display hwtacacs.
Examples
# Set the quiet timer for the primary server to 10 minutes.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer quiet 10

timer realtime-accounting (HWTACACS scheme view)

Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
92