Table of Contents
Advertisement
FiHing
Fit the windshie ld mou lding by pressing it in between
th
e body f rame and the cl
ips.
To ensure
that
the
mo
ul din
g
coin
cides
with th
e
corn
er
joints, fitting
should be done in th
e f
ollowing
order.
First, fit the
lower
moulding with a corner
joint
on. Then fit a side
moulding
also
with
a corner on
.
Finally, fit the remain
-
ing
moulding together with corners and on
to
the
body frame.
Removing the trim mou lding for rear window
l.
Remove the moulding from the rubber strip by
inserting a moistened nylon putt Y knife and
mov-
ing
it all round between the strips
(do
not pull
off the trim
moulding).
2.
Push over the
joining
pieces to one of the halves
of the moulding
.
3. Remove the trim moulding by prising out the
ridge
of th
e
rubber strip from the trim moulding with a
moistened wooden putt
Y
knife and releasing the
trim moulding
.
in the middle with another putt Y
knife as shown in Fig.
8-20.
Lever off the moulding
carefully while releasing
the
rubber strip with the
other putt
Y knife.
Fig.
8-20.
Removing
the trim moulding
VOLVO
24814
Fitting the trim moulding for rear window
Moisten a 4.0 mm
(5/32/1)
leather cord in soap solu-
tion or paraffin and place it in the groove of the
rubber
strip
for the
trim
moulding.
Place one half of the trim moulding in position and
hold it there
while puHing
the leather
cord out
up-
wards over the moulding
so
that it is
pressed against
the rubber strip as shown in
Fig.
8-21. Push over the
joinin
g
pi
eces and re peat
th
e
pro
ced ure with
th
e
oth
er ha
lf of th
e
moulding. Adju st th
e
position of th
e
joining
pie
ces
over the
joints.
Fig.
8-21.
Fitting the trim
moulding
WINDSHIELD
Removing the windshield
l.
Place protective covering over
the
bonnet and front
seats.
2. Remove the windshield wipers arms.
3. Remove the externai trim moulding. See
"Removing
windshield moulding".
4.
Unscrew the inner covering strips and rearview
mirror.
5. Cut the windshield loose with a warm soldering
iron.
Insert the point of the iron
in
between the wind-
shield and the body, from the inside of the
vehicle, see Fig. 8-22. Then draw the soldering
iron
all round the windshield. The windshield can now
be pressed out by hand. Cut off any remaining
strands with a knife.
6. Clean the body (also the windshield if it is to be
refitted) of any tape.
7. Remove any defective clips.
8:
13
Advertisement
Table of Contents
