Table of Contents
Advertisement
Fig. 8-10.
Re
movin
g
win
din
g ha ndle
Removing inner handles and upholstery
l.
Remove
the
arm
rest
in the front door by
unscrew-
ing the screw at the rear edge. Then push the
arm rest forwards
so
that the hook at the front
edge disengages and the armrest can be removed.
The armrest in the rear door is removed by un-
screwing the two screws.
2. Remove the window winding handle by pressing
in the washer towards the door upholstery and
the towards the handle in the same direction as
the handle as shown in Fig
.
8-10. This releases the
spring clip and the winding handle can be taken
off.
When fitting, make sure that the spring clip is
fitted so that its open end faces towards the wind-
ing handle as shown in Fig. 8-10.
3. Remove the door upholstery by inserting a screw-
driver or similar under the upholstery edge and
carefully prising outwards so that the upholstery
comes away.
Latch plates
The latch plate is made of steel and is fitted with a
floating nut plate. The latch plate is adjustable since
the holes in the body are larger than the diameter of
the attaching screw.
The vertical position of the latch plate is control/ed
by closing the door with the press button of the
outer handle pressed in, when the door latch should
slide correctly into the latch plate. The latch plate
should have an inward inclination of 1.5 for the
front doors and
2.5
0
for the rear
do~rs,
see
Fig.
8-11.
Fig.8-11. Latch plate
A.
Front do
o
r 1.5
0
Rear do
o
r 2.5
0
R:emoving front door lock
l
.
Carry out
operations
1-
3
under
"Removing
inn
e
r
handles
and
upholstery".
2.
Remove the
lock
cylinder by uns::rewing
it
attach
-
ing screw which is fitted in the rear
edge
of the
door.
3. Remove
the
locking for
the pul/
rod locking
knob
and take out the pull rod.
4. Remove the locking for
the
inner
door opene
r
push rod.
5. Remove the locking for the
outer
handle
pull rod.
6. Unscrew the two
screws
for the rear winder
rail
on the edge of the door.
7. Unscrew
the three screws for
the
door
lock.
These
screws are placed on the rear
edge
of the
door.
8. The lock
can then
be removed by
carefully
pris-
ing the rear winder rail
forwards.
Rem ovi
ng rear door lock
l.
Carry out operations
1-
3
uilder
"Removing
inner
handles and upholstery".
2. Remove the locking
for
the pull
rod
locking knob.
3.
Remove the locking for the inner door opener
push rod.
4.
Remove the locking for the outer hand le
pull'
rod.
5. Wind down the window
so
that its lower
edge
comes level with the upper
edge
of the door
lock.
6. Remove the weather strip for the
door
frame
.
7. Uns::rew the attaching screws for the door frame
and lift it off.
8
:7
Advertisement
Table of Contents
