Dismantling The Differential; Inspecting The Rear Axle - Volvo 164, 1970 Service Manual

Fig. 4-142. Removing the rear pinion bearing race
1. Removi ng drift SYO 2843
11.
If necessary, pu ll off the rear bearing from t he
pinion with pu ll' e r SYO
2844,
see Fig.
4-143.
The
puller is fitted in t he fo ll owing way (see Fig.
4-144):
Move the pu ll er down over the ro ll ers and press
down the lo ck .ring. Then pull up the pu ll er with
the bolt until the rollers lie flush with the edge of
th e inn er race and the edge on the puller. T ap
out the lock ring with a hamm er.
DISMANTLING THE DifFERENTIAL
1. Re:lease the ring gear bolts and rem ove the crown
wheel.
2.
Dl1ive out the lock pin, see Fig.
4-145,
and then the
shaft for the differenti,al gears. Take out the
differential 9'ears and the thrust washers.
3. Pull off the differential carrier bearings with puller
SYO
2483,
se·e F,ig.
4-146.
Take care of the shims.
INSPECTING THE REAR AXLE
First clean all the parts · t horoughly. Check the bear-
ing raccs and bea'rings . T,he races, rollers or roller
retai,ners must not be scratehed or damaged. All
4: 58
Fig. 4-143. Removing the rear pinion bearing
1. Puller SYO 2844
VO LVO
25527
1
3
Fig. 4-144. Puller fitted
1. Puller is pressed do wn over the roll ers
2. Rollers are pulled up
3. Lock ring knocked sec ure ly into position
Fig. 4-145. Removing the lock pin
l
VO LVO
102436