Volvo 164, 1970 Service Manual page 287

Fig. 8·5. Body
and has welded end pieces. Two front side members
project from the front floor section. At the front they
are joined together by means of a cross-member and
at the rear they are connected to the front cross-
member under the front seats. The front axle member
and bumber support bars are attached to the side
members.
The side section consists of the front pillar, inter-
mediate pillar, rear pilktr, inner and outer cantrails,
roof former, windscreen pillar, rear wheel arch with
wheel arch member, rear mudguard, back plate and
joining plate. The inner cantrail is manufactured of
galvanized sheet steel.
The roof section (see Fig. 8-5 consists of a number
of pressed steel plates. These roof plates form the
upper part of the scuttle, the windscreen opening, the
roof itself, the opening for the rear window and the
front limit of the baggage compartment lid.
The body is noise- and heat-insulated. The insulation
consists of self-adhesive foam rubber material.
8:3