Removing Lock Handles; Fitting And Adjusting Front Door Lock Handle - Volvo 164, 1970 Service Manual

8.
Unscrew the attaching screws for the door lock
and remove the lock from the door. The attaching
screws for the lock are p laced on the rear edge
of the door.
Removing lock handles
When removing the lock handles, the door panel must
be removed (see under "Removing inner handles and
upholstery"). In order to remove the inner door
opener, it is first necessary to remove the clip for the
push rod of the lock. The return spring is then taken
off. Af ter the screws holding the inner door opener
have been removed, the door apener is pulled down -
wards at the same time as the handle is jerked loose
from the lever.
The outer hand le is removed by first taking off the
clip for the pull rod of the lock. The two screws for
Fig.8-12. Front door lock
1. Outer handle
2. Pull rod for inner lock knob
3. Lever
4. Lever
5. Lever
6. Pull rod for ouler handle
7. Locking device
8. Inner door opener
8:8
3-----r'~
4----I~H::-
5--------'1-
the handle are then unscrewed, the front one of
which is placed inside the door and the rear one on
the edge of the door.
Fitting and adiusting front door lock handle
When fitting the inner door opener this is adjusted
as follows:
Fit the inner door opener without tightening the
screws. Attach the lin k arm to the lock and fit the
spring. By the fact that this spring is fitted, the inner
door opener is in its correct position so that the
screws can now be tightened, see Fig. 8-12.
When fitting the outer door handle, this is adjusted
as follows;
Fil' the handle with the I.ink arm on it. Then adjust the
link arm so that the loop falls easily on the pin on
the lock lever, see Fig. 8-12.