Show Interfaces Status - Edge-Core ECS2100-10T Reference Manual

Chapter 11
| Interface Commands
Interface Configuration

show interfaces status

Start Time Discards
------------ -------------
00d 00:00:03
Console#
This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
port-channel channel-id (Range: 1-8)
vlan vlan-id (Range: 1-4094)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type
MAC Address
Configuration:
Name
Port Admin
Speed-duplex
Capabilities
Broadcast Storm
Broadcast Storm Limit
Multicast Storm
Multicast Storm Limit
Unknown Unicast Storm
Unknown Unicast Storm Limit : 500 packets/second
Flow Control
LACP
MAC Learning
Link-up-down Trap
Current Status:
Link Status
Port Operation Status
0
: 1000BASE-T
: 00-E0-0C-00-00-FE
:
: Up
: Auto
: 10half, 10full, 100half, 100full, 1000full
: Enabled
: 500 packets/second
: Disabled
: 500 packets/second
: Disabled
: Disabled
: Disabled
: Enabled
: Enabled
: Up
: Up
– 364 –