Installing The Rear Drive Riser Cage Option - HPE ProLiant DL360 User Manual

10. Install the access panel (Installing the access panel on page 25).
11. Install the server in the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server (Powering up the server on page 24).

Installing the rear drive riser cage option

The rear drive riser cage option supports low-profile PCI riser options in slot 2.
Prerequisites
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• T-10 and T-15 Torx screwdriver
• 1 SFF drive, 2 uFF M.2 drives, or blanks
Procedure
1. Power down the server (Power down the server on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
4. Remove the access panel (Remove the access panel on page 25).
5. Remove the primary PCI riser cage (Removing the primary PCI riser cage on page 27).
6. If installed, remove any expansion boards installed in the riser board.
64 Installing the rear drive riser cage option