Installing A High-Performance Heatsink - HPE ProLiant DL360 User Manual

CAUTION:
Be sure to tighten each heatsink nut fully in the order indicated. Otherwise, boot failure or
intermittent shutdowns might occur.
c. Using a T-30 Torx screwdriver, fully tighten each heatsink screw in the order indicated on the heatsink
label (1 -2 -3 -4) until it no longer turns.
8. If installing a second processor, install high-performance fans in bays 7 and 8. These fans are provided
with the processor option kit.
9. Install the access panel (Installing the access panel on page 25).
10. Install the server in the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Powering up the server on page 24).

Installing a high-performance heatsink

Prerequisites
CAUTION:
Installing a high-performance heatsink requires the installation of a processor assembly onto the
heatsink. To avoid damage to server or components, do not remove or install the processor assembly
when installing or replacing other heatsinks.
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• T-30 Torx screwdriver
• 1/4" flat blade screwdriver or nonconductive tool
Hewlett Packard Enterprise recommends using a nonconductive tool.
Procedure
1. Observe the following alerts.
Installing a high-performance heatsink 91