Drive Options; Hot-Plug Drive Guidelines; Removing The Hard Drive Blank - HPE ProLiant DL360 User Manual

9. Install the access panel (Installing the access panel on page 25).
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Powering up the server on page 24).

Drive options

Depending on the configuration, this server supports SAS, SATA, and NVMe drives. For more information on
drive support, see Device numbers on page 18.
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.

Hot-plug drive guidelines

When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.

Removing the hard drive blank

Remove the component as indicated.
46 Drive options