Disabling Chipset-Tpm; Installing And Enabling The Hpe Tpm 2.0 Gen10 Kit; Installing The Trusted Platform Module Board - HPE ProLiant DL360 User Manual

Disabling Chipset-TPM

CAUTION:
Chipset-TPM is not available after power is removed from the system and the HPE TPM 2.0 Gen10 Kit
is installed. Do not install the HPE TPM 2.0 Gen10 Kit if Chipset-TPM is enabled and the operating
system is using Chipset-TPM features. Otherwise, the OS may go into recovery mode, data loss can
occur, or both. If an OS is installed and using Chipset-TPM, follow the OS vendor instructions to disable
the OS TPM features.
Before installing and enabling the HPE TPM 2.0 Gen10 Kit, verify that Chipset-TPM is disabled. For more
information on disabling Chipset-TPM, see the UEFI System Utilities User Guide for HPE ProLiant Gen10
Servers and HPE Synergy on the Hewlett Packard Enterprise website.

Installing and enabling the HPE TPM 2.0 Gen10 Kit

Installing the Trusted Platform Module board

Preparing the server for installation
Procedure
1. Observe the following warnings:
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power
from the server by removing the power cord. The front panel Power On/Standby button does not
shut off system power. Portions of the power supply and some internal circuitry remain active until
AC power is removed.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website. Follow the instructions on the website to update the system ROM.
3. Power down the server (Power down the server on page 24).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 24).
• Remove the server from the rack (Remove the server from the rack on page 25).
6. Place the server on a flat, level work surface.
7. Remove the access panel (Remove the access panel on page 25).
8. If needed, remove any expansion boards installed in slot 3.
Disabling Chipset-TPM 109