Installing The Primary Gpu Riser And Cable Option - HPE ProLiant DL360 User Manual

9. Install the expansion board.
10. Connect any required internal or external cables to the expansion board.
11. Install the primary PCI riser cage (Install the primary PCI riser cage on page 27).
12. Install the access panel (Installing the access panel on page 25).
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server (Powering up the server on page 24).

Installing the primary GPU riser and cable option

Prerequisites
This option requires the standard primary PCI riser cage.
Before installing this option, be sure that the power supplies support the installation of this option. For more
information, see the Hewlett Packard Enterprise Configurator website.
In addition, be sure you have the following items:
• The components included with the hardware option kit
• HPE DL360 Gen10 CPU1 Cable Kit (If installing a high-powered GPU kit)
Procedure
1. Observe the following alerts:
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server (Power down the server on page 24).
4. Remove all power:
72 Installing the primary GPU riser and cable option