Table of Contents
Advertisement
The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit easily
into the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and insert it again.
7.
Do one of the following:
•
Install the air baffle.
•
Perform steps 9–13 of "Installing a midplane 4LFF SAS/SATA drive cage".
8.
Install the access panel.
9.
Install the server into the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
Use the BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display combined LED
descriptions".
Controller options
The server supports the following storage controllers:
•
Embedded controllers
Enabled through System Utilities and configured through HPE Smart Storage Administrator (Intelligent Provisioning).
•
Type-a controllers
Type-a controllers install in the type-a smart array connector.
•
Type-p controllers
Type-p controllers install in a PCIe expansion slot.
Hardware options installation
103
Advertisement
Table of Contents
