10.10 Mounting The Base Directly To The Wall - NEC UNIVERGE SV8100 System Hardware Manual
Hide thumbs
Also See for UNIVERGE SV8100:
- Features and specifications manual (2210 pages) ,
- Features & specifications manual (1174 pages) ,
- Programming manual (986 pages)
Table of Contents
Advertisement
UNIVERGE SV8100
10.10 Mounting the Base Directly to the Wall
System Hardware Manual
If a standard wall plate is not available, mount the telephone directly on the
wall. Before mounting the telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind
m
the mounting location that could cause a hazard when inserting screws into
the wall.
Make sure the wall material can support the weight of the base unit.
m
Use #10 screws with anchoring devices suitable for the wall material where
m
the base unit will be placed.
To mount the telephone:
1.
Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an
inch between the wall and screw heads for mounting the telephone.
Figure 5-136 Inserting Screws into the Wall for Wall Mounting the Telephone
2.
Plug in and secure the AC adapter.
3.
Plug the AC adapter into the base unit.
4.
Plug one end of the short telephone cord into the LINE jack on the base
unit. Then plug one end of an NEC multiline terminal into the PHONE
jack. Place the telephone cords inside the molded channels on the
bottom of the wall mount stand.
Issue 7.0
5 - 113
Advertisement
Table of Contents
