Led Indications - NEC UNIVERGE SV8100 System Hardware Manual

Issue 7.0
LED Indication
Live LED Busy LED
(Green) (Red)
On On
Flash (1s) On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash 80ms
(On/Off) x 3/
400mS off
4 - 88
3. Connect the cable from the NT1 Network Termination cable to
the CN7 or CN8 connector on the CD-2BRIA blade and/or
PZ-2BRIA daughter board. (Refer to
Blade on page 4-86
blade.)
5.4.3

LED Indications

LED indications for the CD-2BRIA are listed in
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
on page 4-86
Table 4-48 CD-2BRIA LED Indications
Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
With normal operation, the status LED
flashes fast. If trouble was found during
the self diagnostics routine, the status LED
flashes slow.
Once connected, the PKG LED will not be
indicated for the status of Layer 1
for the location of the connectors on the
for the location of the LEDs on the blade.
UNIVERGE SV8100
Link.
Figure 4-26 CD-2BRIA
Table 4-48 CD-2BRIA
Figure 4-26 CD-2BRIA Blade
Remarks
–
When you exceed the system
capacity.
When the main software
version is not matched.
–
–
–
–
–
–
Installing the SV8100 Blades