Configuring The Digital Telephone For The Numbered Keypad; Configuring The Ip Telephone For The Numbered Keypad - NEC UNIVERGE SV8100 System Hardware Manual

Issue 7.0
Japanese
Model A Telephone
Model B UX5000 Telephone
Call Center
Hotel-1
Hotel-2
Retirement Home
Japan 32-Button
Japan Value
Model A Value (retro)
Model B Value
Reserve
5 - 42
4.7.2

Configuring the Digital Telephone for the Numbered Keypad

1. With the telephone not plugged in and the handset on-hook,
press the 4 and 6 buttons on the numbered keypad and
connect the telephone cable.
.
2. Press 2 on the numbered keypad to enter the Button Kit mode.
.
3. Follow the directions below for the type of keypad installed:
Numbered Keypad Type
4. Save to memory by pressing line key 2, 8, 14 or 20. The display
changes back to the Service Class R/W mode and the MW
LED will be lit Red.
5. Press Exit to return the telephone to the idle condition.
4.7.3

Configuring the IP Telephone for the Numbered Keypad

1. Enter the terminal's program mode by pressing HOLD CONF
.
#
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
This places the telephone into Service Class R/W mode. The MW LED
should be lit.
The MW LED should flash.
Table 5-9 Numbered Keypad Type
Push
01
02
03
04
05
06
07
08
09
10
11
12
UNIVERGE SV8100
LED Indication
Line 1 LED on Red
Line 2 LED on Red
Line 1 and 2 LED on Red
Line 1 LED on Green
Line 2 LED on Green
Line 1 and 2 LED on Green
Line 1 LED flashing Red
Line 2 LED flashing Red
Line 1 and 2 LED flashing Red
Line 1 LED flashing Green
Line 2 LED flashing Green
Line 1 and 2 LED flashing Green